Description
The high heating/cooling speed allows for energy savings
of time during calibrations that require multiple verification points.
The calibrator is equipped with a 26×150 mm diameter hole into which are introduced
the reduction inserts to adapt the diameter of the probe to be calibrated to the calibrator.
6 inserts are available with bore sizes from 3.2 to 17.5 mm; other bore sizes can be made
on request up to 1 mm in diameter.
An innovative appliance ventilation system makes it possible to maintain
the temperature above the oven is lower than all competing ovens.
The air flow in the upper part of the oven is deflected towards the rear
of the device by a tangential flow that skims the calibration well; consequently
to this are the thermocouple heads, which contain the connection terminals
compensating cables, they remain at a significantly lower temperature, thereby reducing
heavily mitigate the potential compensation errors produced by head heating.
Specifications
Range: 15 … 650 °C
Stability: ±0.3 °C (over the entire measuring range)
Uncertainty: 0.9 °C (across the entire measuring range)
Warm-up time: from ambient temp to 650 °C in 35 min
Cooling time: from 650 °C to 100 °C in 60 min
Made in Italy
Documentation available in the Download area.
